Imaxrc B6-Compact User Manual Page 1

Browse online or download User Manual for Power suppliers Imaxrc B6-Compact. Imaxrc B6-Compact User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Instruction Manual
www.imaxrc.com
Page view 0
1 2 3 4 5 6 ... 15 16

Summary of Contents

Page 1 - Instruction Manual

Instruction Manualwww.imaxrc.com

Page 2

产品介绍详细参数充电操作说明感谢您购买iMaxRC的B6简易平衡充电器。这款充电器非常轻便小巧,能够充2S,3S,4S,5S和6S锂电池组,它自动判断电池容量,并采用最合适的电流充电。使用之前,请仔细阅读该使用说明书。充电器主输出口平衡口直流输入口输入电压范围:直流电11-18V。最大充电功率:50

Page 3 - Charging Operating

按下图所示,将适用于平衡充电的2-6节锂电池和充电器连接起来。2直流电源输入接口主输出端口对应的平衡接口状态显示灯2S3S4S- +5S6S9当充电池正确插入后,对应的指示灯变成红色并开始进行充电。充电一段时间后,如果红色的灯变成橙色,说明电池容量已达到90%以上,当橙色变为绿色时,说明电池已充满。

Page 4

当电池和充电器连接好之后,充电器会自动进行充电,充电电流由充电器检测电池容量而自动设置。如果电池和充电器连接不正确(插错、反),充电器不会开始充电,并发出警告(蜂鸣声器响,指示灯闪烁)。6个指示灯分别对应平衡口每节电池的状态。对应的插口没有电池充电,指示灯会变成绿色,如果有电池充电,指示灯会变成红色

Page 5 - Features

适配器充电器配件要求适配器的最小功率在50W,电压在DC11~18V之间。 推荐适配器:imaxrc. 12V 5A电源适配器(适用于imaxrc B6系列适配器)。充电器直流输入线输出线4. 输入电压过低(低于11V),绿色的灯依次往中间滚动,并发出急促的响鸣声。5. 连接电池后,若某节电池电压过

Page 6 - Fault description

122、给电池组充电和使用电池时注意电池的正负极与充电器的正确连接。 3、不按图示接线会损坏充电器,主电池线和平衡线都应在充电前如图所示接好。 4、由于市面电池良莠不齐及电池的物理特性和电池类型不同,所以充电器在任何时候都不可在无人监管的情况下工作,切勿在充电器旁放置易燃物,建议放置灭火器等消防设备

Page 7 - Chargers accessories

防伪查询深圳市思科达模型有限公司如需了解更多产品,请登陆我们iMaxRC的官方网站: http://imaxrc.com/info/index.aspx地址:深圳市宝安区西乡宝源路F518时尚创意园F4 201-205电话:+86-755-89830228传真:+86-755-29558361

Page 8

All specications and gures are subject to change without notice. Printed in China © 2012

Page 10

Product IntroductionSpecicationsCharging OperatingThank you for purchasing iMaxRC B6 Compact Easy balance charger. This charger is compact and light,

Page 11

Connect the proper Lipo battery( 2~6 cells) with charger as following:22DC Power SlotMain OutputSeparated correspondingbalance portLEDs show the state

Page 12

When the battery and charger are connected as above, the charger will get into the charging program automatically, the charging current is automatical

Page 13

Fault description42. High accuracy, when the battery is fully charged, the voltage of each cell is: LiPo(4.20±0.01V ). 3. Easy to use and operate. 4.

Page 14

Connecting with adapterChargers accessoriesThe minimum power of the adapter requires more than 50 W and the voltage should be between DC11 ~ 18V.iMaxR

Page 15 - 深圳市思科达模型有限公司

8. If the battery has suspicious reactions during the charge or discharge, such as overheating, venting or leaking , immediately disconnect the batter

Page 16

Security Code QueryiMaxRC CO.,LTDPlease go and visit the website: http://www.imaxrc.com/info/index.aspx• Add: F4 201-205, F

Comments to this Manuals

No comments